...within a loose-tube cable. It can be a headache-inducing task if you don’t have the right tools. If you bend the cable or buffer tubes past their recommended bend radius, or if you allow them to kink, you’ll end up with substandard cable connect...
...Bending a fibre cable • One of the most important considerations when installing fibre optic cable is maintaining the minimum bend radius. Bending a fibre cable excessively may cause the optical signal to refract and escape through the cladd...
...Gbps over a 2-meter cable; v1.2 supports up to 21.6 Gbps. DisplayPort v1.2 also enables you to daisychain up to four monitors with only a single output cable. It also offers the future promise of DisplayPort Hubs that would operate much like a U...
...required. Copper-wire cable can be video coax, miniature coax, or, most commonly, shielded twisted pair with a DB9 or HSSDC connector. Fibre choices include 62.5- or 50-µm multimode and 7- or 9-µm single-mode fibre, all with an SC connector. • Oth...
...on 75-ohm BNC coax cable for transmission — the same cabling traditionally used for analog video communications. • SDI interfaces are standardized by the Society of Motion Picture and Television Engineers (SMPTE) and include: standard-definitio...
...electronic patient records. • The requirements • The most important factor for the medical center was a pixelperfect reproduction of the images at all locations because pixel loss could lead to misdiagnosis. Since the hospital campus is quite lar...
...is always useful for cable management. • Rails. • A main cabinet component is one or two pairs of vertical rails with mounting holes to which you attach your equipment or shelves. The most common spacing between rails is 19 inches with hole-to-ho...
Shopping Basket
Sign in
