...Gigabit over Category 5 cable has been approved, enabling short stretches of Gigabit speed over existing copper cable. Today, you have many choices when implementing Gigabit Ethernet: • 1000BASE-X • 1000BASE-X refers collectively to the IEEE802.3z s...

...is to have a connection cable that supports DDC transmission ( VGA: pins 12 an 15 need to be connected). • An extender or a switch in between? • But what happens if there is an extender or a switch in between? A lot of them do not support DDC at all...

...level not protected by cable shielding, and it's possible to monitor these signals outside the secure zone using a radio receiver. Even without a Trojan, a sophisticated receiver located nearby picks up and views what's on the VGA monitor. • What T...

Video • What you need to know about choosing a reliable end-to-end solution. • Brochure PDF • Connect with the Black Box guaranteed-for-life® ETL Verified structured cabling channel solution! • Black Box Explains • Category 6 •   • GigaTrue® CAT6 ...

...for multifiber ribbon cable that generally contains 6, 8, 12, or 24 fibers. It is defined by IEC-61754-7 and EIA/TIA-604-5-D, also known as FOCIS 5. The MPO connector, combined with lightweight ribbon cable, represents a huge technological advance...

...long haul. Depending on cable type, FDDI networks can stretch up to 100 km in circumference. And FDDI speed can be improved. If the second ring is used as its own network, both rings can operate individually at speeds as fast as 200 Mbps. • This fea...

...of connectors. • The cable • The USB 3.0 cable contains nine wires, four more than USB 2.0, which has one pair for data and one pair for power. USB 3.0 adds two more data pairs, for a total of eight plus a ground. These extra pairs enable USB 3.0...

...is always useful for cable management. • Rails. • A main cabinet component is one or two pairs of vertical rails with mounting holes to which you attach your equipment or shelves. The most common spacing between rails is 19 inches with hole-to-ho...