Face Plates, Modules, Adaptors and Back Boxes

These wall outlet solutions are perfect for Cat5e, Cat6 and Cat6A cabling systems.

Two different types of solution are offered:

25 x 50 mm Integrated Modules
(MODC5E-R2, MODC6-R3)
These snap directly into any of the faceplates on this page.
Punch down the wires directly into the rear of the modules using an IDC tool.
Features
• UTP Jacks
• Rapid Assembly

25 x 50 mm USA Keystone Jacks and Adapter Plates
(ADAPT, ADAPT-ANG, ADAPT-U-S etc.)
Adapter plates snap directly into any of the faceplates on this page.
Snap a keystone jack into the rear of the adapter plate to complete the solution.
Punch down the wires into the jack using an IDC tool as required.
Features
• Wide choice of jacks – Cat5e/ Cat6/ Cat6A coloured, shielded and unshielded and a totally consistent appearance - see links below.
• Keystone jack without ADAPT has a smaller footprint (so pre-termination / pulling is more possible if required)
• Many Cat5e, Cat6, Cat6A jacks are ETL verified for performance as part of a Cat5e , Cat6, Cat6A channel solution.
• Use angled adapter plate (ADAPT-ANG) to enable a shallower bend radius for Cat6 / Cat6A).
• Use unshuttered adapter plate (ADAPT-U-S) for protruding or flush multimedia jacks (Coax, HDMI etc.)
• All ADAPT plates feature a Tie-down point.